Manufacturers of hot water flow meters for supply

Business Type:Buyer seeking purchase

Field of expertise:Insurance

Company Nature:Non-Profit Organization

Company Scale:1000+ People

Company Region:无

Contact Number:+86-25-52155837

Legal Person:

Conpany Site:https://flow-meter.com.au

Mobile Phone:WeChat: +86 18936759191

Post Code:201261

Fax:+86-25-52155837

QQ:Onlick:WhatsApp: +86 18936759191

Email:[email protected]

Company Address:SILVER AUTOMATION INSTRUMENTS LTD

Description:

How to use and install the purchased hot water flow meter?

Installation

1. When using, the hot water flowmeter belongs to the type of velocity flowmeter, so the pipeline should be cleaned and tidy before installation.. If the side medium is not clean, a filter needs to be added. Avoid substances such as fibers and particles in some liquids as much as possible, otherwise the turbine and bearings may get stuck and the flow rate cannot be measured.

2、 During the measurement process, it is necessary to make requirements for the sensor of the flowmeter, which must be filled with the measuring liquid inside the sensor before opening the outlet valve.

3、 It is advisable to maintain the impeller every six months. During the installation process, it is important to pay attention to the position relationship between the guide components and the impeller.

4、 In order to achieve good measurement results, liquid measurement will be equipped with filters, which need to be kept clean whether working or not.

5、 There are also some tips for installing sensors. Usually, the key transmission cable of the sensor can be laid overhead or buried underground (iron pipes should be covered when buried). Especially when powered on, the impeller can be manually rotated to determine the rotation of the turbine flowmeter. When the display is normal, installing the sensor in this way will be better. From the principle of probe manufacturing, we can see that its core is the probe, and its performance can determine the service life, measurement accuracy, repeatability, and low flow rate characteristics of the flowmeter. The probe is composed of a stainless steel sheath and platinum resistance wire. The sheath of stainless steel is conductive, and platinum heating wire is also conductive, which requires the filler between them to have good thermal conductivity, but not conductivity. This leads to the core content of all thermal flow meters - the filling material and packaging process of the heating probe.

2. How to install the flow sensor of Midea electric water heater F60-30G2? Is it installed at the inlet or outlet? Tool The flow sensor of Midea electric water heater F60-30G2 is located at the inlet. Remove the water inlet cover, insert the sensor into the edge of the cover, wire it, and then close it. The liquid flow sensor (also known as the flute shaped averaging tube flowmeter) is a new type of differential pressure flow absolute wheel measuring element developed based on the principle of pitot tube speed measurement. Our company has introduced German technology to produce the Annubar flowmeter, which has a novel design, reasonable structure, high accuracy, low pressure loss, and easy installation and use. It is replacing orifice plates and other detection components with its special advantages and international quality. The characteristics of liquid flow sensors include easy installation, low pressure loss, high strength, no wear and tear, and no leakage, making them an ideal product to replace orifice plates.

3. Which flowmeter is good for heating hot water?

Electromagnetic flowmeter, ultrasonic flowmeter or vortex flowmeter are recommended for heating hot water, depending on the specific working conditions.

. The following analysis will be conducted from two aspects: type characteristics and core selection elements:

1. Type characteristics of flow meters. Electromagnetic flow met

『SILVER Official Website SERVICE』